The Workbench (60"x30" Cast Iron Table)


Legs: Standard Legs
Price:
Sale price$8,751.00 NZD


Save On Ding and Dents

This 60"x30" table is the size typical work desk, but easily extendable. It packs a lot of weight for its dimensions so it's extra sturdy. This size is also designed for joining together to make larger tables.

Join 2 tables to make a 5' x 5'


This table is the size typical work desk, but easily extendable.

120" x 60" (10' x 5') Configurations

A secondary intention of this table was to design it for connecting or expansion in the future. Connect 2 tables to form a 5x5 surface or 3 tables in an H formation to create a 10x5 area.




Other Tables

5/8" or 16mm

  • 2" Grid
  • 16mm (5/8") Hole

Our Table

3/4"

  • 2" Grid
  • 80% More Holes Than 28mm
  • Same Number Of Holes As 5/8" or 16mm
  • 3/4" Hole (45% Larger Cross Section Compared to 5/8" or 16mm)

Other Tables

28mm

  • 4" Grid or 100mm grid
  • 28mm 1.1" Hole

Tabletop

1” thick Gray Cast Iron on top and 1” thick sides, additional reinforcement ribs underneath. Machined flat on all 5 sides to within +/- 0.0025” per 24” x 24” area. Side apron on the tables are 8” tall with 3 rows of holes.


3D Model - Drag Image Across

Leg Options

We have three leg options to best suit your shop needs. This table requires 6 legs, if you buy the table on this page with the leg options, there is no need to order separate legs.

Standard Leg

Legs are 26” tall with +/- 1” adjustment range on the leveling pads. The table height is 8” inches, so with these legs you’ll have a table surface height of 34”.

Height Adjustable

These have a range of 22” to 36” with 1” increments and +/- 1” adjustment on the leveling pads. The table height is 8” inches, so with these legs you’ll have a table surface height of 30-44” height.

Height Adjustable + Caster

Use these legs for a table that’s easy to maneuver around without a crane or forklift. These have a range of 22” to 30” with 1” increments and +/- 1” adjustment on the leveling pads. The table height is 8” inches, so with these legs you’ll have a table surface height of 30” to 38”.

Factory Seconds


Producing large castings with perfect surfaces is a difficult task. The larger the surface area, the more likely there is to be some air pockets or voids during the casting process that only show up after machining.

Our castings are optimized to produce a high quality top surface, but even a typical table will often have some small imperfections on the top or side of the machined surfaces.

When the tables experience a higher number or severity of surface defects we designate them as factory seconds and sell them at a discounted price.

Customers who order factory seconds will receive photographs of the table before shipping.

You may also like

Recently viewed